Hale Electronic Scale


Standard Features
9″- 18″ Profile Ideal where height or access pose any type of installation problems. Available in steel or
concrete deck
UniLatch Latching System A UniBridge exclusive! Reduces installation time as bridges self-align & center.
Bolts are virtually eliminated!
UniBridge Parallel Link Suspension Permits simple service of the load cells
Safety Side Rails Exclusive UniBridge radius side rails alleviate tire damage & promote safer operation
Surface Mounted No pit required
Bump Bolts Eliminate check rods, speeds installation, permits easier scale adjustment
Conduit System Designed to protect cables and speed up installation time
Examined and Approved Meets or exceeds all requirements set forth in Handbook 44. Approved for 50,000 lb x
5 lb 100,000 lb 10 lb 200,000 lb x 20 lb COC# 88-030A2
Jacking Pad Factory installed for use with hydraulic jacks
Summing Boards Individual adjustment pots for each position and section on all scales. Gaseous diodes are on
all boards for added lightning protection
UniModular Design Modules are designed for future expansion
Surface Preparation All surfaces are thoroughly sandblasted prior to finishing
Standard Finish Catalyzed UniBridge Epoxy Blue or Gray
Bolt Down All anchoring is done after installation permitting perfect placement of scale
Cover Plates Easily removed for load cell maintenance
Fully Electronic No moving parts
Steel Deck UniBridge exclusively uses extra-heavy, high strength safety plate on all bridge decks
UniBridge DL9000 Load Cells Complete with intrinsic lightning and voltage surge protection

Please click here for a printable brochure.




ncwm     nist

©2017 UniBridge Scale System. All rights reserved. Valid XHTML | CSS page.